Cosmetics Formulation Development

Formula 1 Plankton Artemia Extract 2% Creatine 100 1% B3 10 % Sodium Lactate Plus 1% Pitera Remaining Formula 2 DMAE 3% Copper Peptide 3% Vitamin B5 5% MOIST24 5% remaining Pitera can be mixed together without reducing the value or causing negative effects, right? thank you

Hello, both formulas can be mixed with no problem, but keep the pH at the right level. It is a weak acid range of 4.5-6.5. Some ingredients will cause the pH to be higher than this range. This may require the addition of a weak acid, such as Lactic Acid , glycolic acid to adjust the pH in the range. recommended

Formula 1 Plankton Artemia Extract 2% Creatine 100 1% B3 10 % Sodium Lactate Plus 1% Pitera Remaining 1. If adjusting plankton to 5% can be used in this formula, right? Just maybe worry about the gooey and then reduce the % of พิเทร่า down to 100 2. Can add L-Carnitine ( Carnitine ) 3%, right? 3. If vitamin B6 acidic It can be used in this formula to adjust the pH. of vitamin B3 to be reduced to replace the use of lactic acid or citric, and try to measure the pH in the appropriate range, the rest is พิเทร่า complete 100 thank you

Hello, 1,2,3 can do it?

1. Creatine 100 1% Allantoin 0.2% Sodium Metabisulfite 0.15% B3 5% B5 3% ฺ B6 1.5% Gluco Bright 4% L-Carnitine 3% Sym White 0.5% Butylene Glycol 1.5% (mixed with Sym White ) Ume Extract 4% Sodium Lactate Plus 1% Witch Hazel the remaining 20% Pitera Yes, can I mix normally? 2 from Formula 1, change , Gluco Bright , B3 , Sym White , as 4MSK 3% tranexamic 3% Ethyl Ascorbic acid 3% Other than that old Can I mix it? 3 From Formula 1, change , Gluco Bright , B3 , is zinc glycinate, the rest is the same. Can I mix it? 4 From formula 1, change Butylene Glycol to spread Sym White to Phospholipid 2% + lipid moist 2%, the rest is the same. Can you mix it?

Hello

1. Creatine 100 1% Allantoin 0.2% Sodium Metabisulfite 0.15% B3 5% B5 3% ฺ B6 1.5 % Gluco Bright 4% L-Carnitine 3% Sym White 0.5% Butylene Glycol 1.5% (mixed with Sym White ) Ume Extract 4% Sodium Lactate Plus 1% Witch Hazel 20% remaining Pitera

not sure Butylene Glycol 1.5 % will be enough to dissolve Sym White or not? may have to increase the proportion of Butylene Glycol a bit more, 2,3 can do it, 4 can't. Because there is no water-oil binder in the formula, a stratification can occur.

4 can't do Because there is no water-oil binder in the formula, stratification can occur. Lipid moisture use Phospholipid is a little weave in the formula, is that enough? From the query Phospholipid can be mixed with both water and fat. In this case, lipid moisture is used as an emulsifier instead of oil. Is that enough? It's a secondary emulsifier. Lip Moist put a little.

Hello Phospholipid can help coordinate. but usually just used as co- Emulsifier (sync helper) cannot work as Emulsifier or the main binder of the formula, in case you try. result It might be a stratification problem in the long run.

Plankton Artemia Extract Marine Plankton (Lifting, Tightening) type of plankton does bioderm use?

Formula 2 DMAE 3% Copper Peptide 3% Vitamin B5 5% MOIST24 5% 1. Can you add 4 characters below as well? Enter ไวท์คาเวีย 1-3% beta glucan Adenosine Liposome ฺ B3 2. Copper Peptide should not include Disodium EDTA but if you put it in a formula that should delay discoloration, for example SymWhite should be used Sodium Metabisulfite 0.2% alone is enough? yes