Cosmetics Formulation Development

Before using the Light Cream Maker, the steps are as follows (produce 40 kg. per time).

1. Mix the Light Cream Maker with the oil and stir well.

2. Pour the water mixture into the oil bit by bit, stirring continuously.

It will increase the cream texture little by little. Until all the water is added, it will be creamy.

then blend with the machine Homogenizer to make the cream smooth and beautiful

But later lots do the same. But it won't be creamy immediately.

must be blended with a machine Homogenizer before going up to the cream

So it takes longer to spin.

Asked why the creamy texture of the Light Cream Maker

Therefore, it cannot become creamy by stirring by hand. or need any additional steps

because the components of Light Cream Maker in the MSDS have changed from the original

thank you

hello

Light Cream Maker can be used in 2 ways.

1. Mix with water and blend well. Get a white opaque gel Then you can add oil to the opaque white gel. Blend until combined. You will get a creamy texture. (Can be stirred by hand)

2. Mix with the oil mixture well. And while the water is spinning Gradually add the oil portion. (Can use human hands as well)

In the case of coordinating a large amount of oil It is recommended to use a blender instead of stirring by hand to increase the stability of the recipe.

Light Cream Maker has not changed any components, but the documents have been updated according to the FDA's substance name requirements.

The nature of the substances produced in each lot may be slightly different. But it will still be within the specs as specified. (You can check the specs by clicking on "Techniques" on the product page.) If you find any abnormalities in the nature of the substance. or does not conform to the spec, can notify Customer Relations care@myskinrecipes.com Please check.

thank you