How to make gel using Pro Polymer (Gel Maker)
คำถาม
Could you please provide instructions on how to make a simple gel using Pro Polymer™ (Gel Maker), including the recommended usage rate for a general texture, the typical usage range for adjusting thickness, and the mixing procedure, especially considering formulas with high amounts of glycerin or propylene glycol?
คำตอบ
To make 1 kilogram (1000 grams) of a simple gel using Pro Polymer™ (Gel Maker), the recommended usage rate is 0.8%. This means you would use 8 grams of Pro Polymer™ (Gel Maker) for a general gel texture.
The usage rate for Pro Polymer™ (Gel Maker) is typically between 0.5% and 5%. You can adjust the amount within this range depending on the desired thickness. Using more than 3% can create a very thick, pudding-like texture.
Mixing Instructions:
Mix Pro Polymer™ (Gel Maker) into the water phase. Sprinkle the powder onto the liquid and stir slowly for 3-5 minutes until a smooth gel texture forms. Avoid over-blending (above 2500 rpm) as this can damage the polymer. It is recommended to let the mixture sit for 1 day after initial mixing to allow the Pro Polymer to fully absorb the water, then blend slowly again for easier dissolution.
If your formula contains glycerin or propylene glycol at amounts higher than 5%, mix the Pro Polymer with the glycerin or propylene glycol first before adding to the water.
ผลิตภัณฑ์ที่เกี่ยวข้องที่กล่าวถึง
