Mixing method for clear liquid toner formulation
Question
I am developing a clear liquid toner formulation and would like to confirm the correct mixing method for the following ingredients: Distilled Water, Propylene Glycol, Butylene Glycol, Glycerine, Phenoxyethanol, Flora Solve, Essential Oil, Menthol, and Allantoin. I previously discussed potentially adding Soy Protein or a thickener like Xanthan Gum, but for this version, I want a clear liquid. Could you please provide the step-by-step mixing instructions for this specific formula?
Answer
Based on your final list of ingredients and the discussion thread, here is a proposed method for mixing your clear liquid toner formulation. Please note that Allantoin is adjusted to 0.3% as 1% may not fully dissolve in this formula, based on staff advice. If you intended to include Soy Protein or a thickener like Xanthan Gum (as discussed previously), the formula and method would need adjustment.
Formula (Adjusted Allantoin):
- Distilled Water: 82.1%
- Propylene Glycol: 5%
- Butylene Glycol: 5%
- Glycerine: 5%
- Phenoxyethanol: 1%
- Flora Solve: 1% (Recommended for dissolving Menthol and Essential Oil)
- Essential Oil: 0.5%
- Menthol: 0.1%
- Allantoin: 0.3%
Mixing Method:
- Water Phase:
- Measure the required amount of distilled water.
- Add Allantoin to the water and stir until it dissolves. (Note: Allantoin can be slow to dissolve).
- Add Propylene Glycol, Butylene Glycol, Glycerine, and Phenoxyethanol to the water phase.
- Stir the water phase thoroughly until all ingredients are well mixed.
- Oil/Solvent Phase:
- In a separate container, combine Flora Solve, Menthol, and Essential Oil.
- Gently warm this mixture (e.g., in a warm water bath) to around 30-40°C and stir until the Menthol crystals are completely dissolved and the mixture is clear.
- Combine Phases:
- Slowly add the Oil/Solvent phase (from step 2) to the Water Phase (from step 1) while stirring continuously.
- Continue stirring until the entire mixture is clear and homogenous.
- Final Check:
- Check the clarity and consistency of the final product.
Important Notes:
- This method assumes you are making a liquid toner. If you want a thicker texture like a mask, you would need to add a thickener (e.g., Xanthan Gum) to the formula and incorporate it into the water phase according to its specific instructions (often by dispersing it in water and letting it hydrate to form a gel before adding other ingredients).
- Ensure all equipment is clean and sanitized before starting.
- Store the final product in a clean, airtight container.