Mixing Procedure for Multi-Ingredient Cream/Serum

Here are the recommended steps for mixing your cream formulation:

Ingredients:

• Distilled water: Remaining percentage
• Tranexamic Acid: 3%
• Safe-B3 (Niacinamide): 3%
• Copper Peptide: 3%
• Alpha Arbutin: 2%
• GlucoBright (N-Acetyl Glucosamine): 3%
• Silky Cream Maker: 1%
• Phenoxyethanol: 1%

Mixing Procedure:

1. Measure the required amount of Distilled Water into a clean container.
2. Add Tranexamic Acid to the water and stir until completely dissolved. Gentle warming (e.g., up to 40-50°C) can help, but is not strictly necessary if it dissolves easily at room temperature.
3. Add Safe-B3 (Niacinamide) to the mixture and stir until dissolved.
4. Add Copper Peptide to the mixture and stir until dissolved.
5. Add Alpha Arbutin to the mixture and stir until dissolved.
6. Add GlucoBright (N-Acetyl Glucosamine) to the mixture and stir until dissolved. Ensure all active ingredients are fully dissolved and the solution is clear before proceeding.
7. Add Silky Cream Maker to the mixture. Stir or mix thoroughly until the desired cream or gel-cream consistency is achieved. This may require consistent mixing for a few minutes. Avoid whipping air into the mixture.
8. Once the mixture has cooled down (if heated) to below 40°C, add Phenoxyethanol and stir to ensure it is evenly distributed.
9. (Optional but Recommended) Check the pH of your final product and adjust if necessary to a skin-friendly range (typically pH 5.0-6.0).

Package your finished product in a suitable container.