Cosmetics Formulation Development

Formula (%) 1. SPF Protect Ultra 2... ......15 2. LipidSoft Lite ..................15 3.ZnO powder............ ......3 4.TiO2 powder.................1 5. Polyethylene Wax ..........3 6. Milk Lotion Maker ..........3 7. Satin Cream Maker ......0.7 8. Phenoxyethanol SA........1 9.H2O.... ................................58.3 Method of blending oil: 1+2+5+6, heat until dissolved (85 C) water: 9, heat as oil (85 C) Gradually pour water into the oil, blend until smooth, add 7 when the cream is creamy. Then add 3,4,8 1. There is a problem as shown in the picture (like sedimentation of milk), ask for the cause and how to fix it. 2.Is there too much oil in the recipe? Really want to reduce the volume 2 but afraid to support physical sunscreen Not sure if 1 is considered supported. [url= Tribehenin physical sunscreen can you give me some advice? Tribehenin / Butter Cream Maker / Cetearyl Alcohol / or which substitutes 6,7 in the formula? Can I? Thank you in advance

Hello. 1. The wrong step is that add water to the oil. Change to add oil into the water while adding the water and the oil. Must have the same temperature and must continually spin the water with at least cycles. 500 rpm. Gradually add the oil into a little at a time until all the ingredients are powdered. to add to the formula in the last step After getting the cream, it will be easier by blending and gradually adding powder into it. Continue blending until the formula is smooth. 2. According to the formula, it should be able to support it. not the type that the member reported) may try to add Milk Lotion Maker go a little more 3. Milk Lotion Maker will combine more oil than other Cream Makers Tribehenin and Cetearyl Alcohol acts only as a texturizer or a texture (thick + weight the word weight does not mean gooey But it's creamy) If you want to use it in this recipe, you can do it. This results in more meat and thicker.

Formula (%) 1. LipidSoft Dry .................30 3.ZnO powder............. ....5 4.TiO2 powder.................4 5. Polyethylene Wax ..........3 6. Milk Lotion Maker ..........4 7. Xanthan ................................0.5 8. Phenoxyethanol SA........1 9.H2O.... ................................58.3 Follow the mixing method above by pouring the oil into the water. (same temperature) as recommended by the team But still have the same problem as shown in the picture. Please give me a way to fix it.

more The temperature of both phases during blending was 85 C, blended at high speed. As it is hot, the meat will begin to become smooth. But when it cools down, it will become the texture as shown in the picture.

Hello, ZnO powder TiO2 powder, what type do you choose?

Zinc Oxide 200nm easydisperse Titanium Dioxide 30nm SilkTouch

Hello, this recipe, the team will send the lab to test it. Because I don't understand as well what is the problem? Please, please confirm that Polyethylene Wax is Soft type.

Verify that it is Polyethylene Wax type soft, thank you.

Hello, the team has tested the mix. no problems found After setting the formula, leave it at 30C for 24 hours. The next step will be to test 8C for you. The texture of the meat is as shown in the attached picture.

I would like to know the recipe and method of mixing in detail as well.